If you are checking for a leak, look at the sweep hand to see if it is moving.When you are done, close the meter cap to prevent damage from the lens and carefully replace the meter box lid.There are approximately 7.48 gallons of water in 1 cubic foot. These reads are located on your billing statement. Subtract your current reading from your last reading to learn how much water you have used since your last bill.You will use all numbers on the dial which will include black and white areas. Write down the numbers, reading from left to right. The reading is taken from the figures shown below the words CUBIC FEET. Locate the dial on the meter it will resemble the odometer in a car. Check to see if you have a straight read or digital meter, definitions are listed below.Face the meter so that you are reading the numbers from left to right. Lift the metal cover over the face of the meter to uncover the lens.Please visually examine the area around the meter to make sure there are no harmful snakes, insects, or other animals inside. Insert the tool into one of the holes and pry the lid off. Carefully remove the lid of the meter box by using a tool such as a large screwdriver.If you are taking a read to check for a leak, make sure no one is using water in the home and that any water-using appliances are not in use (dishwasher, washing machine, sprinklers, etc).If you are unable to locate the meter, call Utility Billing at 53 for assistance. Your water meter is located in the ground inside a rectangular box with a metal, plastic or concrete lid marked “water,” usually at the front of the property. PG&E Public Safety Power Shutoff (PSPS)įirst you need to locate your water meter.Water Efficiency Materials and Resources.Sewer Concerns and Customer Responsibility.
How to Identify an EID Service Employee.Small Farm and Agricultural Metered Irrigation.